Shure Wireless Office Headset 35 Uživatelský manuál stáhnout pdf

Shure cartridges can be used in DJ or Hi-Fi applications.

Note: The M70BX is not recommended for heavy scratching.

25, 35, and 44 Series

Phono Cartridges

Install Your Cartridge

Carefully remove the stylus from the cartridge. See 1.

Figure 1.

Use needle-nose pliers to connect the colored wires 2.

from the tonearm headshell to the corresponding

pins on the cartridge. See Table 1 and Figure 2.

NOTE: The larger terminal goes onto the M25C

cartridge and the smaller terminal goes onto the

arm of the turntable.

HEADSHELL WIRE COLOR PIN

RIGHT “HOT” RED R

RIGHT GROUND GREEN RG

LEFT “HOT” WHITE L

LEFT GROUND BLUE LG

Figure 2

Figure 3

Figure 4

Standard DJ Setup: Mount cartridge at rear of headshell. Set tonearm height to 4-5. Set tracking force

to 3 grams. Set anti-skate control to 0.

Figure 5

Choose a Method for Cartridge Positioning

Hi-Fi Setup: For maximum fidelity and minimal record wear, position the cartridge using an alignment

protractor or the overhang gauge supplied with your turntable. Level your tonearm (See Figure 7). Use

Table 2 and “Setting a Precise Tracking Force”, below, to set the typical tracking force for your cartridge.

Set the anti-skate control to the same number as the tracking force.

4 - 5

3 grams

4 - 5

Unorthodox DJ Setup: Reverse the counterweight and mount it flush with the end of the tonearm.

Mount cartridge (with headshell weight) flush with the front edge of the headshell. Set anti-skate

control to 0.

Figure 6

Level Your Tonearm

Figure 7

Extra Skip Resistance for DJ’s:

Mount the cartridge at a 23 degree angle as

shown, so that the cartridge points to the tonearm

pivot. Set anti-skate to 0.

27C3116 (Rev. 4)

Printed in U.S.A.

Table 1. Cartridge Wiring

Attach the cartridge to the headshell using the screws 1.

supplied. See Figure 3. Tighten the screws after

positioning the cartridge (and headshell weight, if

desired) according to one of the methods described

below.

Carefully insert the stylus into the cartridge.2.

Figure 1

1 2 3 4

Shrnutí obsahu

Strany 1 - Phono Cartridges

Shure cartridges can be used in DJ or Hi-Fi applications. Note: The M70BX is not recommended for heavy scratching.25, 35, and 44 SeriesPhono Cartridge

Strany 2

Cartridge Replacement StylusStylus Color Stereo Output (1 KHz at 5 cm/sec peak recorded velocity)Frequency Response in HzTracking force range (grams)T

Strany 3 - Installation de la cellule

Shure-Tonabnehmer können für DJ- oder Hi-Fi-Anwendungen verwendet werden. Hinweis: Der M70BX wird nicht für starkes „Scratching“ empfohlen.Die Abtastn

Strany 4 - • 特殊DJ设定（图6）：把配重反转，并

United States, Canada, Latin America, Caribbean:5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int’l F