Shure T series Uživatelský manuál

Symetrix White Paper:Connect the Shure Dante SeriesWireless Receiver to SymNet Dante Hardware6408 216th Street SW | Mountlake Terrace, WA 98043 USAT

Step 11:In Dante Controller on the Routing Tab, expand Dante Receives and Dante Transmitters, the SymNet DSP should now show a Dante connection to the

Subscribe SymNet xOut 12 Hardware to Dante Transmitter from the Shure ULXD4D:The SymNet xOut 12 can be used as a stand-alone Dante receiver; however i

Step 8:Click the “New Dante Flow” button.Step 9:A new Dante flow will be created and Dante Flow Module Properties will pop-up. • Name for new Dante

Step 10:Click the OK button twice, once for the “New Dante Flow” and once for “Dante Flow Manager”.Step 11: Double click the first channel of the xOut

Step 12:The “Select Dante Flow” dialog will open. Be sure the Shure ULXD4D Dante flow that was created in steps 8 and 9 is high-lighted in the Transmi

Step 13:The xOut 12 Unit Properties should now show a subscription to the Shure ULXD4D Dante channels.Step 14:Push the Composer site file to the SymNe

Step 15:In Dante Controller on the Routing Tab, expand Dante Receives and Dante Transmitters, the SymNet xOut 12 should now show a Dante connection to

Symetrix White Paper: Connect the Shure Dante Series Wireless Receiver to SymNet Dante Hardware© 2013 Symetrix, Inc. All rights reserved. Printed in t

ContentsiiTable of Contents6408 216th Street SW | Mountlake Terrace, WA 98043 USAT +1.425.778.7728 F +1.425.778.7727 | www.symetrix.coOverview ...

Symetrix White Paper:Connect the Shure Dante Series Wireless Receiver to SymNet Dante HardwareOverviewDante is the most interoperable digital audio bu

ii. Separate Networks Used for Dante and Control: A separate network switch is used for Dante and Ethernet Control, so

Subscribe SymNet DSP Hardware to Dante Transmitted from the Shure ULXD4D:These steps outline the procedure used in a SymNet Edge, Radius 12x8 or Radiu

Step 3:Next, click on the Device Status tab, and then double-click on the device name. In this case it is ULXD4D-ffeceb. This will launch the Dante

Step 5:On the Routing tab of Dante Controller, expand the Shure ULXD4D in the upper area of Dante Transmitters and confirm that the two named channels

Step 6:Next, open SymNet Composer, select locate hardware (Ctrl+Shift+L), and then enter the design view by double clicking on the gray Edge, Radius 1

Step 9:Wire the Dante modules outputs into any module input or analog output. In this example the Dante module is wired into the AEC Aux signals #3 an